ASTM C1218_C1218M-20 - Standard Test Method for Water-Soluble Chloride in Mortar and Concrete
Standard Test Method for Water-Soluble Chloride in Mortar and Concrete
Označení normy: | C1218_C1218M-20 |
Vydáno: | 01.06.2020 |
Status: | Active |
Počet stran: | 3 |
Sekce: | 04.02 |
Označení: | chloride; chloride content; concrete; mortar; water-soluble chloride; |
1.1 This test method provides procedures for the sampling and analysis of hydraulic-cement mortar or concrete for chloride that is water soluble under the conditions of test.
1.2 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes shall not be considered as requirements of this standard.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as a standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.