Označení normy: | BS 1202-1:2002 |
Počet stran: | 18 |
Vydáno: | 2002-02-07 |
ISBN: | 0 580 37316 9 |
Status: | Standard |
BS 1202-1:2002
This standard BS 1202-1:2002 Specification for nails is classified in these ICS categories:
- 21.060.50 Pins, nails
1.1 This part of the standard specifies requirements, including dimensions and finish, for the types of steel nails listed in 1.1 and 1.1.2.
NOTE The nearest former s.w.g. numbers are included in a separate column in each table for convenience only. They do not form part of the specification.
1.1.1 Wire nails
Convex head roofing nails (chisel or diamond points)
Pipe nails (chisel point)
Hardboard panel pins (round shank)
Hardboard panel pins (square shank)
Lath nails
Plasterboard nails (jagged shank)
Tile pegs
Tram nails with flat or raised head with chisel point
Square twisted shank flat head nails
Dowels
Tenter hooks
Annular ringed shank flat head nails
Helical threaded shank flat head nails
Duplex head nails
1.1.2 Cut nails
Cut clasp nails
Cut floor brads
1.2 The types of nail are illustrated in the diagrams accompanying Table 1, Table 2, Table 3, Table 4, Table 5, Table 6, Table 7, Table 8, Table 9, Table 10, Table 11, Table 12, Table 13, Table 14, Table 15 and Table 16.
NOTE Requirements for the following nails, which were previously included in this British Standard, are given in BS EN 10230-1.
Round plain head nails
Round lost head nails
Clout or slate nails
Extra large head clout or felt nails
Panel pins
Oval brad head nails
Oval lost head nails
Spring head twisted shank nails
Washer head slab nails