Přihlásit seRegistrovat se
Jazyk czen
Menu
KontaktOBCHODNÁPOVĚDAE-ReadingNovinky
Hledání
0
Celková cena
0 Kč
Cena s DPH / bez DPH
Hlavní stránka>BS 328-5:1983 Drills and reamers Specification for the dimensions of countersinks and counterbores
Sponsored link
sklademVydáno: 1983-07-29
BS 328-5:1983 Drills and reamers Specification for the dimensions of countersinks and counterbores

BS 328-5:1983

Drills and reamers Specification for the dimensions of countersinks and counterbores

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4800 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
480.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1440.00 Kč
Anglicky Tisk
Skladem
4800 Kč
Označení normy:BS 328-5:1983
Počet stran:16
Vydáno:1983-07-29
ISBN:0 580 13264 1
Status:Standard
Popis

BS 328-5:1983


This standard BS 328-5:1983 Drills and reamers is classified in these ICS categories:
  • 25.100.30 Drills, countersinks, reamers
  • 25.100.20 Milling tools

This Part of this British Standard specifies the dimensions of the following:

  1. counterbores with Morse taper shanks and detachable pilots;
  2. countersinks with parallel shanks;
  3. countersinks with Morse taper shanks.

Appendix A shows extracts from BS 4500-1, giving details of the tolerances specified. Appendix B specifies details of counterbores with cutting diameters designated in inches.

NOTE The titles of the publications referred to in this standard are listed on the inside back cover.


Specifies the dimensions of counterbores with parallel shanks and integral pilots; counterbores with Morse taper shanks and detachable pilots; countersinks with parallel shanks, and countersinks with Morse taper shanks. Appendix A shows extracts from BS 4500:Part 1 giving details of the tolerances specified and Appendix B gives details of counterbores with cutting diameters designated in inches.
Tisk