Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Cena s DPH / bez DPH
Hlavní stránka>BS 5131-1.9:1985 Methods of test for footwear and footwear materials. Adhesives Measurement of green strength of adhesive joints
Sponsored link
sklademVydáno: 1985-05-31
BS 5131-1.9:1985 Methods of test for footwear and footwear materials. Adhesives Measurement of green strength of adhesive joints

BS 5131-1.9:1985

Methods of test for footwear and footwear materials. Adhesives Measurement of green strength of adhesive joints

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4154 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
415.40 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1246.20 Kč
Anglicky Tisk
Skladem
4154 Kč
Označení normy:BS 5131-1.9:1985
Počet stran:10
Vydáno:1985-05-31
ISBN:0 580 14211 6
Status:Standard
Popis

BS 5131-1.9:1985


This standard BS 5131-1.9:1985 Methods of test for footwear and footwear materials. Adhesives is classified in these ICS categories:
  • 83.180 Adhesives
  • 61.060 Footwear

This Section describes a method for measuring the resistance to peeling of an adhesive joint between two sheet materials immediately after it is made. This is usually known as the green strength.

The main purpose of the test is to enable the green strength of joints made with various solvent-based adhesives between specific soling and upper materials to be compared. The test can also be used for joints between other materials provided that at least one of them is flexible.

NOTE Adequate green strength is especially important for sole-attaching adhesives during shoe manufacture, as otherwise the sole bond may partially fail cohesively, i.e. within the adhesive film, after leaving the press.


Describes a method for measuring the resistance to peeling of an adhesive joint between two sheet materials after it is made. This is usually known as the green strength.