Cena s DPH / bez DPH
Hlavní stránka>BS 5326:1976 Specification. Internal broaching tools and pull chuck locations
Sponsored link
sklademVydáno: 1976-04-30
BS 5326:1976 Specification. Internal broaching tools and pull chuck locations

BS 5326:1976

Specification. Internal broaching tools and pull chuck locations

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4032 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
403.20 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1209.60 Kč
Anglicky Tisk
Skladem
4032 Kč
Označení normy:BS 5326:1976
Počet stran:10
Vydáno:1976-04-30
ISBN:0 580 09095 7
Status:Standard
Popis

BS 5326:1976


This standard BS 5326:1976 Specification. Internal broaching tools and pull chuck locations is classified in these ICS categories:
  • 25.100.25 Tools for planing and broaching machines
  • 25.060.20 Dividing and tool-workpiece holding devices

This standard specifies a range of nominal shank dimensions for both the pull and tail ends of internal broaches for use on broaching machines, vertical type.

The standard specifies certain dimensions for locating the pull chuck in the pull block of broaching machines, vertical internal type. The constant dimension between the top of the pull block and the platen surface is also given.

The standard is particularly applicable to automatic handling of broaching tools.


Range of nominal shank dimensions for pull and tail ends of internal broaches for use on broaching machines, vertical type, and dimensions for locating the pull chuck in the pull block. Gives constant dimensions between the top of the pull block and the platen surface. Particularly applies to automatic handling of broaching tools.