Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Cena s DPH / bez DPH
Hlavní stránka>BS 6160-1:1989 Radio equipment used in mobile services General requirements and conditions of measurement
Sponsored link
sklademVydáno: 1989-09-29
BS 6160-1:1989 Radio equipment used in mobile services General requirements and conditions of measurement

BS 6160-1:1989

Radio equipment used in mobile services General requirements and conditions of measurement

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
6820 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
682.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2046.00 Kč
Anglicky Tisk
Skladem
6820 Kč
Označení normy:BS 6160-1:1989
Počet stran:28
Vydáno:1989-09-29
ISBN:0 580 17191 4
Status:Standard
Popis

BS 6160-1:1989


This standard BS 6160-1:1989 Radio equipment used in mobile services is classified in these ICS categories:
  • 33.060.99 Other equipment for radiocommunications

This standard applies to radio transmitting and receiving equipment and systems used in the mobile services.

This standard is restricted to land and mobile stations in the mobile services and to portable and personal equipment which may operate in one or more radio-frequency channels in the frequency range below 1 000 MHz and is intended for the transmission and the reception, either in a simplex or a duplex mode, of emissions modulated by a single information channel.

In this standard, the equipment includes the aerial (antenna) change-over device or the duplexer, if used, but does not include:

  • the aerial (antenna) or aerial (antenna) system except in the case of equipment using integral aerials (antennas);
  • the input transducer of the transmitter;
  • the output transducer of the receiver except in the case of equipment using integral transducers (see note).

NOTE The performance of the equipment depends upon that of the input and the output transducers used. Assessing the performance of these transducers may be the subject of separate measurements which are outside the scope of this standard.

This standard also provides for testing certain special sub-systems (see Clause 10).