BS AU 50-1.0.1:1999
Tyres and wheels. Tyres. General Method of test for measuring tyre uniformity
Označení normy: | BS AU 50-1.0.1:1999 |
Počet stran: | 20 |
Vydáno: | 1999-05-15 |
ISBN: | 0 580 30624 0 |
Status: | Standard |
BS AU 50-1.0.1:1999
This standard BS AU 50-1.0.1:1999 Tyres and wheels. Tyres. General is classified in these ICS categories:
- 83.160.01 Tyres in general
- 43.040.50 Transmissions, suspensions
This International Standard specifies test methods carried out under controlled conditions for verifying the uniformity of tyres for passenger cars, commercial vehicles and motorcycles.
NOTE Lack of uniformity around a tyre produces variations in forces applied by the tyre to the vehicle and this influence is repeated with each revolution of the tyre. At the present state of the art, however, it is impossible to manufacture perfectly uniform tyres. A rigid control of the complete manufacturing process can only minimise the unavoidable imperfections of materials, components and processes affecting uniformity.
Methods for measuring the geometrical run-out of the tyre in both radial and lateral directions are covered, as well as methods for measuring the following parameters:
- radial force variation;
- lateral force variation;
- ply steer;
- conicity.
Not all of these measurements will necessarily be relevant in every situation.
This International Standard does not include methods for measuring the static and the dynamic unbalance nor methods related to tyre-wheel assemblies.
The test methods specified in this International Standard are not intended for the gradation of tyres or the definition of quality levels.
Specifies test methods carried out under controlled conditions for verifying uniformity of tyres for passenger cars, commercial vehicles and motorcycles.