Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Cena s DPH / bez DPH
Hlavní stránka>BS EN 10217-7:2021 - TC Tracked Changes. Welded steel tubes for pressure purposes. Technical delivery conditions Stainless steel tubes
Sponsored link
sklademVydáno: 2022-01-27
BS EN 10217-7:2021 - TC Tracked Changes. Welded steel tubes for pressure purposes. Technical delivery conditions Stainless steel tubes

BS EN 10217-7:2021 - TC

Tracked Changes. Welded steel tubes for pressure purposes. Technical delivery conditions Stainless steel tubes

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
12586 Kč
Anglicky Tisk
Skladem
12586 Kč
Označení normy:BS EN 10217-7:2021 - TC
Počet stran:104
Vydáno:2022-01-27
ISBN:978 0 539 18164 7
Status:Tracked Changes
Popis

BS EN 10217-7:2021 - TC


This standard BS EN 10217-7:2021 - TC Tracked Changes. Welded steel tubes for pressure purposes. Technical delivery conditions is classified in these ICS categories:
  • 77.140.75 Steel pipes and tubes for specific use
  • 23.040.10 Iron and steel pipes

This document specifies the technical delivery conditions in two test categories for welded tubes of circular cross-section made of austenitic and austenitic-ferritic stainless steel which are intended for pressure and corrosion resisting purposes at room temperature, at low temperatures or at elevated temperatures.

NOTE

Once the reference of this document is published in the Official Journal of the European Union (OJEU) under Directive 2014/68/EU, pressure equipment directive, presumption of conformity to the Essential Safety Requirements (ESR) of Directive 2014/68/EU is limited to technical data of materials in this document and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of the Pressure Equipment Directive are satisfied, needs to be done by the designer of the pressure equipment, taking also into account the subsequent manufacturing processes which could affect properties of the base materials.