Hlavní stránka>BS EN 1113:2015 Sanitary tapware. Shower hoses for sanitary tapware for water supply systems of type 1 and type 2. General technical specification
Sponsored link
sklademVydáno: 2015-04-30
BS EN 1113:2015
Sanitary tapware. Shower hoses for sanitary tapware for water supply systems of type 1 and type 2. General technical specification
Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
6820 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
This standard BS EN 1113:2015 Sanitary tapware. Shower hoses for sanitary tapware for water supply systems of type 1 and type 2. General technical specification is classified in these ICS categories:
91.140.70 Sanitary installations
23.040.70 Hoses and hose assemblies
This European Standard specifies: - the dimensional, leaktightness, mechanical and hydraulic characteristics with which shower hoses should comply; - the procedures for testing these characteristics. This European Standard applies to shower hoses of any material used for ablutionary purposes and intended for equipping and supplementing sanitary tapware for baths and showers. This European Standard applies to shower hoses connected downstream of the obturator of the tapware. Hoses which are an integral part of sanitary tapware (sink and wash basin mixing valves) or hoses intended to connect sanitary tapware to the water supplies are not covered by this European Standard. Details of pressures and temperatures are given in Table 1.
