Cena s DPH / bez DPH
Hlavní stránka>BS EN 14598-3:2005 Reinforced thermosetting moulding compounds. Specification for sheet moulding compound (SMC) and bulk moulding compound (BMC) Specific requirements
Sponsored link
sklademVydáno: 2005-05-25
BS EN 14598-3:2005 Reinforced thermosetting moulding compounds. Specification for sheet moulding compound (SMC) and bulk moulding compound (BMC) Specific requirements

BS EN 14598-3:2005

Reinforced thermosetting moulding compounds. Specification for sheet moulding compound (SMC) and bulk moulding compound (BMC) Specific requirements

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
6448 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
644.80 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1934.40 Kč
Anglicky Tisk
Skladem
6448 Kč
Označení normy:BS EN 14598-3:2005
Počet stran:24
Vydáno:2005-05-25
ISBN:0 580 46020 7
Status:Standard
Popis

BS EN 14598-3:2005


This standard BS EN 14598-3:2005 Reinforced thermosetting moulding compounds. Specification for sheet moulding compound (SMC) and bulk moulding compound (BMC) is classified in these ICS categories:
  • 83.120 Reinforced plastics
This part of prEN 14598 specifies the requirements for physical and chemical properties of Sheet moulding Compounds (SMC) and Bulk Moulding Compound (BMC) and compression or injection moulded specimens. The selection in this part is limited to those materials the composition and properties of which are significantly different. Furthermore the selection is limited to those materials which are of more general technical and / or economical importance. The properties which are used for the characterization of the moulding compounds, the test methods and the test conditions are based on part 2 of this standard. The list of properties is selected, initially, from those general test methods found in ISO 10350-1, Plastics - Acquisition and presentation of comparable single-point data - Part 1 : Moulding materials. The moulding compounds are divided into types corresponding to their composition and properties. The designation of the types of moulding compounds is based on part 1 "Designation and basis for specifications" of this standard.