Cena s DPH / bez DPH
Hlavní stránka>BS EN 17314:2020 Industrial trucks. Specifications and test methods. Operator restraint systems other than lap-type seat belts
Sponsored link
sklademVydáno: 2020-01-23
BS EN 17314:2020 Industrial trucks. Specifications and test methods. Operator restraint systems other than lap-type seat belts

BS EN 17314:2020

Industrial trucks. Specifications and test methods. Operator restraint systems other than lap-type seat belts

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4800 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
480.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1440.00 Kč
Anglicky Tisk
Skladem
4800 Kč
Označení normy:BS EN 17314:2020
Počet stran:18
Vydáno:2020-01-23
ISBN:978 0 580 51890 4
Status:Standard
Popis

BS EN 17314:2020


This standard BS EN 17314:2020 Industrial trucks. Specifications and test methods. Operator restraint systems other than lap-type seat belts is classified in these ICS categories:
  • 53.060 Industrial trucks

This document specifies the tests for the verification of restraint systems against the risk of lateral ejection of the operator for:

  • counterbalanced lift trucks with centre control, sit down and non-elevating operator position (see EN ISO 3691?1:2015, 4.7.8), with a rated capacity up to and including 10 000 kg;

  • tractors as defined in EN 12312?15 (airport ground equipment);

  • burden carriers (as defined in ISO 5053-1:2015, 3.25) with a maximum speed of more than 25 km/h with seated operator;

  • other types of industrial trucks equipped with such a restraint system.

Counterblanced lift trucks, tractors and burden carriers are named hereafter as trucks.

NOTE 1

Industrial tractors as defined in ISO 5053-1 1 do not need a restraint system in general.

This document describes type tests for a specific combination of truck and restraint system.

This standard does not cover:

  • the risk due to frontal ejection;

  • the monitoring of the protective position of the operator restraint system as defined in EN 16307?1 :— 2 , 4.16;

  • the testing of seat belts.

NOTE 2

The testing of sealt belts is covered by ISO 24135?1 .

The document is not applicable for the retrofit of trucks with restraint systems.

This document does not give any requirements on the need for a restraint system.