BS EN 17333-2:2020

This standard BS EN 17333-2:2020 Characterisation of one component foam is classified in these ICS categories:

• 83.180 Adhesives

This document specifies test methods for the evaluation of the expansion properties for moisture curing, self-curing activatable or water drying foams dispensed from single pressurized foam containers.

This document does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this document to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

The following test methods are described:

• Method 1 – Dimensional stability: This test method describes how to determine the dimensional stability (shrinkage or expansion) of cured foam under typical and extreme conditions.

• Method 2 – Curing pressure: This method describes how to determine the generation of pressure during the curing process of an OCF.

• Method 3 – Post expansion: This method describes how to measure the expansion of a dispensed froth during the curing phase.