Cena s DPH / bez DPH
Hlavní stránka>BS EN 302-3:2023 - TC Tracked Changes. Adhesives for load-bearing timber structures - Test methods Determination of the effect of acid damage to wood fibres by temperature and humidity cycling on the transverse tensile strength
Sponsored link
sklademVydáno: 2023-02-23
BS EN 302-3:2023 - TC Tracked Changes. Adhesives for load-bearing timber structures - Test methods Determination of the effect of acid damage to wood fibres by temperature and humidity cycling on the transverse tensile strength

BS EN 302-3:2023 - TC

Tracked Changes. Adhesives for load-bearing timber structures - Test methods Determination of the effect of acid damage to wood fibres by temperature and humidity cycling on the transverse tensile strength

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
6510 Kč
Anglicky Tisk
Skladem
6510 Kč
Označení normy:BS EN 302-3:2023 - TC
Počet stran:36
Vydáno:2023-02-23
ISBN:978 0 539 26077 9
Status:Tracked Changes
Popis

BS EN 302-3:2023 - TC


This standard BS EN 302-3:2023 - TC Tracked Changes. Adhesives for load-bearing timber structures - Test methods is classified in these ICS categories:
  • 83.180 Adhesives
This document specifies a method for determining the effect on bond strength of damage to wood fibres caused by the action of acids from the adhesive or primer used in the gluing process during climatic cycling. It is applicable to the following applications: a) for assessing the compliance of adhesives with EN 301, EN 15425 and EN 16254; b) for assessing the suitability and quality of adhesives for load-bearing timber structures; c) for determining if the adhesive after bonding has a damaging influence on the strength of the wood due to chemical action. This test is intended primarily to obtain performance data for the classification of adhesives for load-bearing timber structures according to their suitability for use in defined climatic environments. This test is carried out on Norway spruce (Picea abies L.) or Beech (Fagus sylvatica L.). This method is not intended to provide data for structural design and does not necessarily represent the performance of the bonded member in service.