BS EN 60252-1:2011+A1:2013

This standard BS EN 60252-1:2011+A1:2013 AC motor capacitors is classified in these ICS categories:

• 31.060.70 Power capacitors
• 31.060.30 Paper and plastics capacitors

This part of IEC 60252 applies to motor capacitors intended for connection to windings of asynchronous motors supplied from a single-phase system having a frequency up to and including 100 Hz, and to capacitors to be connected to three-phase asynchronous motors so that these motors may be supplied from a single-phase system.

This standard covers impregnated or unimpregnated capacitors having a dielectric of paper, plastic film, or a combination of both, either metallized or with metal-foil electrodes, with rated voltages up to and including 660 V.

Motor start capacitors are covered by IEC 60252-2.

NOTE The following are excluded from this standard:

• shunt capacitors of the self-healing type for a.c. power systems of up to and including 1 000 V nominal voltage (see IEC 60831-1);

• shunt capacitors of non-self-healing type for a.c. power systems of up to and including 1 000 V nominal voltage (see IEC 60931-1);

• shunt capacitors for a.c. power systems having a nominal voltage above 1 000 V (see IEC 60871-1);

• capacitors for induction heat-generating plants, operating at frequencies between 40 Hz and 24 000 Hz (see IEC 60110-1);

• series capacitors (see IEC 60143);

• coupling capacitors and capacitor dividers (see IEC 60358);

• capacitors to be used in power electronic circuits (see IEC 61071);

• small a.c. capacitors to be used for fluorescent and discharge lamps (see IEC 61048);

• capacitors for suppression of radio interference (IEC publication under consideration);

• capacitors intended to be used in various types of electrical equipment and thus considered as components;

• capacitors intended for use with d.c. voltage superimposed on a.c. voltage.

The object of this standard is

1. to formulate uniform rules regarding performance, testing and rating;

2. to formulate specific safety rules;

3. to provide a guidance for installation and operation.