Cena s DPH / bez DPH
Hlavní stránka>BS EN IEC 60311:2019 Electric irons for household or similar use. Methods for measuring performance
Sponsored link
sklademVydáno: 2019-10-28
BS EN IEC 60311:2019 Electric irons for household or similar use. Methods for measuring performance

BS EN IEC 60311:2019

Electric irons for household or similar use. Methods for measuring performance

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
9280 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
928.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2784.00 Kč
Anglicky Tisk
Skladem
9280 Kč
Označení normy:BS EN IEC 60311:2019
Počet stran:60
Vydáno:2019-10-28
ISBN:978 0 580 91662 5
Status:Standard
Popis

BS EN IEC 60311:2019


This standard BS EN IEC 60311:2019 Electric irons for household or similar use. Methods for measuring performance is classified in these ICS categories:
  • 97.060 Laundry appliances

This International Standard applies to electric irons for household or similar use.

The purpose of this document is to state and define the principal performance characteristics of electric irons for household or similar use which are of interest to the user and to describe the standard methods for measuring these characteristics.

Electric irons covered by this standard include

  • dry irons;

  • steam irons;

  • vented steam irons with motor pump;

  • spray irons;

  • steam irons with separate water reservoir or boiler/generator having a capacity not exceeding 5 l.

This document is concerned neither with safety nor with performance requirements.

NOTE The primary characteristic to be taken into account in assessing the performance of an electric iron is its basic ability to produce a smooth finish to textile materials, without risk of scorching or other damage. lt has not proved possible to devise a single method which will measure this characteristic in a consistently reproducible way and measurements have therefore been included to check certain factors, such as the temperature of the sole-plate at the mid-point, sole-plate temperature distribution, etc., which affect the basic characteristic. In evaluating the results, while a very exceptional result in any one of them may significantly affect performance, there is considerable latitude in the combination of results which will give satisfactory ironing performance, and too much significance is not given to minor differences in any one result.