Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Cena s DPH / bez DPH
Hlavní stránka>BS EN IEC 61400-27-2:2020 Wind energy generation systems Electrical simulation models. Model validation
Sponsored link
sklademVydáno: 2020-10-01
BS EN IEC 61400-27-2:2020 Wind energy generation systems Electrical simulation models. Model validation

BS EN IEC 61400-27-2:2020

Wind energy generation systems Electrical simulation models. Model validation

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
9486 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
948.60 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2845.80 Kč
Anglicky Tisk
Skladem
9486 Kč
Označení normy:BS EN IEC 61400-27-2:2020
Počet stran:68
Vydáno:2020-10-01
ISBN:978 0 580 96151 9
Status:Standard
Popis

BS EN IEC 61400-27-2:2020


This standard BS EN IEC 61400-27-2:2020 Wind energy generation systems is classified in these ICS categories:
  • 27.180 Wind turbine energy systems
IEC 61400-27-2:2020 specifies procedures for validation of electrical simulation models for wind turbines and wind power plants, intended to be used in power system and grid stability analyses. The validation procedures are based on the tests specified in IEC 61400-21 (all parts). The validation procedures are applicable to the generic models specified in IEC 61400-27-1 and to other fundamental frequency wind power plant models and wind turbine models. The validation procedures for wind turbine models focus on fault ride through capability and control performance. The fault ride through capability includes response to balanced and unbalanced voltage dips as well as voltage swells. The control performance includes active power control, frequency control, synthetic inertia control and reactive power control. The validation procedures for wind turbine models refer to the tests specified in IEC 61400-21-1. The validation procedures for wind turbine models refer to the wind turbine terminals.