Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Cena s DPH / bez DPH
Hlavní stránka>BS EN IEC 61726:2022 - TC Tracked Changes. Cable assemblies, cables, connectors and passive microwave component. Screening attenuation measurement by the reverberation chamber method
Sponsored link
sklademVydáno: 2022-12-09
BS EN IEC 61726:2022 - TC Tracked Changes. Cable assemblies, cables, connectors and passive microwave component. Screening attenuation measurement by the reverberation chamber method

BS EN IEC 61726:2022 - TC

Tracked Changes. Cable assemblies, cables, connectors and passive microwave component. Screening attenuation measurement by the reverberation chamber method

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
9548 Kč
Anglicky Tisk
Skladem
9548 Kč
Označení normy:BS EN IEC 61726:2022 - TC
Počet stran:64
Vydáno:2022-12-09
ISBN:978 0 539 24334 5
Status:Tracked Changes
Popis

BS EN IEC 61726:2022 - TC


This standard BS EN IEC 61726:2022 - TC Tracked Changes. Cable assemblies, cables, connectors and passive microwave component. Screening attenuation measurement by the reverberation chamber method is classified in these ICS categories:
  • 33.120.30 RF connectors
  • 33.120.10 Coaxial cables. Waveguides
  • 33.120.01 Components and accessories in general
This standard describes the measurement of screening attenuation by the reverberation chamber measurement method, also called mode stirred chamber method. This standard is applicable to screening attenuation measurements of cable assemblies, cables, connectors, and passive microwave components, such as waveguides, phase shifters, diplexers/multiplexers, power dividers/combiners and etc. Modern electronic equipments have shown a demand for methods for testing screening attenuation performance of microwave components over their whole frequency range. Convenient measurement methods have existed for lower frequencies and components of regular shape. These measurement methods are described in IEC 62153 series standards. For much higher frequencies and for components of irregular shape, the reverberation chamber method should be used. Theoretically, the reverberation chamber method has no upper limit of the measurement frequency, but it is limited by the quality and sensitivity of the measurement system, and the lower limit of the measurement frequency is restricted by the size of the reverberation chamber.