Cena s DPH / bez DPH
Hlavní stránka>BS EN IEC 63132-3:2020 Guidance for installation procedures and tolerances of hydroelectric machines Vertical Francis turbines or pump-turbines
Sponsored link
sklademVydáno: 2020-07-02
BS EN IEC 63132-3:2020 Guidance for installation procedures and tolerances of hydroelectric machines Vertical Francis turbines or pump-turbines

BS EN IEC 63132-3:2020

Guidance for installation procedures and tolerances of hydroelectric machines Vertical Francis turbines or pump-turbines

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
7564 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
756.40 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2269.20 Kč
Anglicky Tisk
Skladem
7564 Kč
Označení normy:BS EN IEC 63132-3:2020
Počet stran:40
Vydáno:2020-07-02
ISBN:978 0 580 99497 5
Status:Standard
Popis

BS EN IEC 63132-3:2020


This standard BS EN IEC 63132-3:2020 Guidance for installation procedures and tolerances of hydroelectric machines is classified in these ICS categories:
  • 27.140 Hydraulic energy engineering
IEC 63132-3:2020 The purpose of this this part of IEC 63132 is to establish, in a general way, suitable procedures and tolerances for the installation of a vertical Francis turbine or pump-turbine. This document presents a typical assembly and whenever the word “turbine” is used in this document, it refers to a vertical Francis turbine or a pump-turbine. There are many possible ways to assemble a unit. The size of the machine, design of the machine, layout of the powerhouse or delivery schedule of the components are some of the elements that could result in additional steps, the elimination of some steps and/or assembly sequences.
It is understood that a publication of this type will be binding only if, and to the extent that, both contracting parties have agreed upon it.
This document excludes matters of purely commercial interest, except those inextricably bound up with the conduct of installation.
The tolerances in this document have been established upon best practices and experience, although it is recognized that other standards specify different tolerances.
Wherever this document specifies that documents, drawings or information is supplied by a manufacturer (or by manufacturers), each individual manufacturer will furnish the appropriate information for their own supply only.