Cena s DPH / bez DPH
Hlavní stránka>BS EN ISO 16784-1:2024 Corrosion of metals and alloys. Corrosion and fouling in industrial cooling water systems Guidelines and requirements for conducting pilot-scale evaluation of corrosion and fouling control additives for open recirculating cooling water systems
Sponsored link
sklademVydáno: 2025-01-13
BS EN ISO 16784-1:2024 Corrosion of metals and alloys. Corrosion and fouling in industrial cooling water systems Guidelines and requirements for conducting pilot-scale evaluation of corrosion and fouling control additives for open recirculating cooling water systems

BS EN ISO 16784-1:2024

Corrosion of metals and alloys. Corrosion and fouling in industrial cooling water systems Guidelines and requirements for conducting pilot-scale evaluation of corrosion and fouling control additives for open recirculating cooling water systems

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
6820 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
682.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2046.00 Kč
Anglicky Tisk
Skladem
6820 Kč
Označení normy:BS EN ISO 16784-1:2024
Počet stran:24
Vydáno:2025-01-13
ISBN:978 0 539 18325 2
Status:Standard
Popis

BS EN ISO 16784-1:2024


This standard BS EN ISO 16784-1:2024 Corrosion of metals and alloys. Corrosion and fouling in industrial cooling water systems is classified in these ICS categories:
  • 77.060 Corrosion of metals
This document specifies general requirements and parameters for the pilot test evaluation of corrosion and scaling control additives in open recirculating cooling water systems. This document covers parameters including test unit design, operation, water quality and contamination. It also covers the design and operation of pilot test devices as well as parameters to be evaluated in pilot test units. This document covers the criteria that are used in pilot scale testing programmes for selecting water treatment programmes for specific recirculating cooling water systems. This document is only applicable to open recirculating cooling water systems. It does not apply to closed cooling systems and once-through cooling water systems. This document applies only to systems that incorporate shell and tube heat exchangers with standard uncoated smooth tubes and cooling water on the tube side. This document does not apply to heat exchangers with shell-side water, plate and frame and/or spiral heat exchangers and other heat exchange devices. However, when the test conditions are properly set up to model the surface temperature and shear stress in more complex heat transfer devices, the test results can predict the results of operating heat exchangers of that design. The test criteria established in this document are not intended to govern the type of bench and pilot scale testing normally carried out by water treatment companies as part of their proprietary product development programmes. However, water treatment companies can choose to use the criteria in this document as guidelines in the development of their own product development test procedures.