Cena s DPH / bez DPH
Hlavní stránka>BS EN ISO 21305-1:2019 Plastics. Polycarbonate (PC) moulding and extrusion materials Designation system and basis for specifications
Sponsored link
sklademVydáno: 2019-03-14
BS EN ISO 21305-1:2019 Plastics. Polycarbonate (PC) moulding and extrusion materials Designation system and basis for specifications

BS EN ISO 21305-1:2019

Plastics. Polycarbonate (PC) moulding and extrusion materials Designation system and basis for specifications

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
3906 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
390.60 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1171.80 Kč
Anglicky Tisk
Skladem
3906 Kč
Označení normy:BS EN ISO 21305-1:2019
Počet stran:14
Vydáno:2019-03-14
ISBN:978 0 580 92953 3
Status:Standard
Popis

BS EN ISO 21305-1:2019


This standard BS EN ISO 21305-1:2019 Plastics. Polycarbonate (PC) moulding and extrusion materials is classified in these ICS categories:
  • 83.080.20 Thermoplastic materials

This document establishes a system of designation for polycarbonate (PC) moulding and extrusion materials, which can be used as the basis for specifications.

The types of polycarbonate plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties:

  1. melt volume-flow rate;

  2. Charpy notched impact strength;

and on information about the intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials.

This document is applicable to all polycarbonate homopolymers and copolymers. It applies to unmodified materials ready for normal use and materials modified, for example, by colorants, additives, fillers, reinforcing materials, and polymer modifiers.

It is not intended to imply that materials having the same designation give necessarily the same performance. This document does not provide engineering data, performance data or data on processing conditions which can be required to specify a material. If such additional properties are required, they are intended to be determined in accordance with the test methods specified ISO 21305‑2, if suitable.

In order to designate a thermoplastic material to meet particular specifications, the requirements are given in data block 5 (see 4.6).