Cena s DPH / bez DPH
Hlavní stránka>BS EN ISO 294-1:2017 Plastics. Injection moulding of test specimens of thermoplastic materials General principles, and moulding of multipurpose and bar test specimens
Sponsored link
sklademVydáno: 2017-08-04
BS EN ISO 294-1:2017 Plastics. Injection moulding of test specimens of thermoplastic materials General principles, and moulding of multipurpose and bar test specimens

BS EN ISO 294-1:2017

Plastics. Injection moulding of test specimens of thermoplastic materials General principles, and moulding of multipurpose and bar test specimens

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
7564 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
756.40 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2269.20 Kč
Anglicky Tisk
Skladem
7564 Kč
Označení normy:BS EN ISO 294-1:2017
Počet stran:40
Vydáno:2017-08-04
ISBN:978 0 580 87569 4
Status:Standard
Popis

BS EN ISO 294-1:2017


This standard BS EN ISO 294-1:2017 Plastics. Injection moulding of test specimens of thermoplastic materials is classified in these ICS categories:
  • 83.080.20 Thermoplastic materials

This document specifies the general principles to be followed when injection moulding test specimens of thermoplastic materials and gives details of mould designs for preparing two types of specimen for use in acquiring reference data, i.e. type A1 and type B1 test specimens as specified in ISO 20753, and provides a basis for establishing reproducible moulding conditions. Its purpose is to provide consistent descriptions of the main parameters of the moulding process and to establish a uniform practice in reporting moulding conditions. The particular conditions required for the reproducible preparation of test specimens will vary for each material used and are given in the International Standard for the relevant material or are to be agreed upon between the interested parties.

NOTE Interlaboratory tests with acrylonitrile/butadiene/styrene (ABS), styrene/butadiene (SB) and poly(methyl methacrylate) (PMMA) have shown that mould design is an important factor in the reproducible preparation of test specimens.