Cena s DPH / bez DPH
Hlavní stránka>BS EN ISO 294-4:2019 Plastics. Injection moulding of test specimens of thermoplastic materials Determination of moulding shrinkage
Sponsored link
sklademVydáno: 2019-02-11
BS EN ISO 294-4:2019 Plastics. Injection moulding of test specimens of thermoplastic materials Determination of moulding shrinkage

BS EN ISO 294-4:2019

Plastics. Injection moulding of test specimens of thermoplastic materials Determination of moulding shrinkage

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4650 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
465.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1395.00 Kč
Anglicky Tisk
Skladem
4650 Kč
Označení normy:BS EN ISO 294-4:2019
Počet stran:18
Vydáno:2019-02-11
ISBN:978 0 580 92865 9
Status:Standard
Popis

BS EN ISO 294-4:2019


This standard BS EN ISO 294-4:2019 Plastics. Injection moulding of test specimens of thermoplastic materials is classified in these ICS categories:
  • 83.080.20 Thermoplastic materials

This document specifies a method of determining the moulding shrinkage and post-moulding shrinkage of injection-moulded test specimens of thermoplastic material in the directions parallel to and normal to the direction of melt flow.

For the determination of shrinkage of thermosets, see ISO 2577[2].

Moulding shrinkage as defined in this document excludes the effects of humidity uptake. This is included in post-moulding shrinkage and thus in total shrinkage. For cases when post-moulding shrinkage is caused by the uptake of humidity only, see ISO 175[1].

Moulding shrinkage as defined in this document represents the so-called free shrinkage with unrestricted deformation of the cooling plates in the mould during the hold period. It is considered, therefore, as the maximum value of any restricted shrinkage.