Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Cena s DPH / bez DPH
Hlavní stránka>BS EN ISO 9773:2024 - TC Tracked Changes. Plastics. Determination of burning behaviour of thin flexible vertical specimens in contact with a small-flame ignition source
Sponsored link
sklademVydáno: 2024-10-16
BS EN ISO 9773:2024 - TC Tracked Changes. Plastics. Determination of burning behaviour of thin flexible vertical specimens in contact with a small-flame ignition source

BS EN ISO 9773:2024 - TC

Tracked Changes. Plastics. Determination of burning behaviour of thin flexible vertical specimens in contact with a small-flame ignition source

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
6882 Kč
Anglicky Tisk
Skladem
6882 Kč
Označení normy:BS EN ISO 9773:2024 - TC
Počet stran:47
Vydáno:2024-10-16
ISBN:978 0 539 33793 8
Status:Tracked Changes
Popis

BS EN ISO 9773:2024 - TC


This standard BS EN ISO 9773:2024 - TC Tracked Changes. Plastics. Determination of burning behaviour of thin flexible vertical specimens in contact with a small-flame ignition source is classified in these ICS categories:
  • 13.220.40 Ignitability and burning behaviour of materials and products
  • 83.080.01 Plastics in general
This document specifies a small-scale laboratory screening procedure for comparing the relative burning behaviour of vertically oriented thin and relatively flexible plastics specimens exposed to a low-energy-level flame ignition source. NOTE  These specimens cannot be tested using method B of IEC 60695-11-10:2013 since they distort or shrink away from the applied flame source without igniting. This test method determines the afterflame and afterglow times of specimens. The classification system described in Annex A is intended for quality control and the preselection of component materials for products. The classification established by this method of test is applicable only to the material used for the specimens. NOTE  Test results are influenced by material components, e.g. pigments, fillers, concentrations of fire retardants.