Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Přihlásit seRegistrovat se
Jazyk czen
Menu
KontaktOBCHODNÁPOVĚDAInfobarE-ReadingNovinky
Hledání
0
Celková cena
0 Kč
Cena s DPH / bez DPH
Hlavní stránka>BS ISO 16031-2:2003 Aerospace fluid systems. O-Rings, inch series. Inside diameters and cross sections, tolerances and size-identification codes Standard tolerances for non-hydraulic systems
Sponsored link
sklademVydáno: 2008-03-31
BS ISO 16031-2:2003 Aerospace fluid systems. O-Rings, inch series. Inside diameters and cross sections, tolerances and size-identification codes Standard tolerances for non-hydraulic systems

BS ISO 16031-2:2003

Aerospace fluid systems. O-Rings, inch series. Inside diameters and cross sections, tolerances and size-identification codes Standard tolerances for non-hydraulic systems

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4898 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
489.80 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1469.40 Kč
Anglicky Tisk
Skladem
4898 Kč
Označení normy:BS ISO 16031-2:2003
Počet stran:20
Vydáno:2008-03-31
ISBN:978 0 580 53199 6
Status:Standard
Popis

BS ISO 16031-2:2003


This standard BS ISO 16031-2:2003 Aerospace fluid systems. O-Rings, inch series. Inside diameters and cross sections, tolerances and size-identification codes is classified in these ICS categories:
  • 49.080 Aerospace fluid systems and components

This part of ISO 16031 specifies the inside diameters, cross-sections, tolerances and size identification codes for inch O-rings used in aerospace fluid systems intended for use in non-hydraulic systems.

This part of ISO 16031 is applicable, provided that suitable tooling is available, to O-rings made from all other elastomeric materials other than nitrile and ethylene propylene materials, for which ISO 16031-1 specifies the dimensions.

Specifications for O-rings with an inside diameter d1 ≤ 12,7 mm have been taken from ISO 16031-1, because the same tolerances are applicable to the O-rings in this part of ISO 16031.


Tisk