Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Cena s DPH / bez DPH
Hlavní stránka>BS ISO 22621-5:2010 Plastics piping systems for the supply of gaseous fuels for maximum operating pressures up to and including 2 MPa (20 bar). Polyamide (PA) Fitness for purpose of the system
Sponsored link
sklademVydáno: 2010-05-31
BS ISO 22621-5:2010 Plastics piping systems for the supply of gaseous fuels for maximum operating pressures up to and including 2 MPa (20 bar). Polyamide (PA) Fitness for purpose of the system

BS ISO 22621-5:2010

Plastics piping systems for the supply of gaseous fuels for maximum operating pressures up to and including 2 MPa (20 bar). Polyamide (PA) Fitness for purpose of the system

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
7998 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
799.80 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2399.40 Kč
Anglicky Tisk
Skladem
7998 Kč
Označení normy:BS ISO 22621-5:2010
Počet stran:34
Vydáno:2010-05-31
ISBN:978 0 580 61546 7
Status:Standard
Popis

BS ISO 22621-5:2010


This standard BS ISO 22621-5:2010 Plastics piping systems for the supply of gaseous fuels for maximum operating pressures up to and including 2 MPa (20 bar). Polyamide (PA) is classified in these ICS categories:
  • 83.140.30 Plastics pipes and fittings for non fluid use
  • 75.200 Petroleum products and natural gas handling equipment

This part of ISO 22621 specifies the requirements of fitness for purpose of the polyamide (PA) piping system, intended to be buried and used for the supply of gaseous fuels at maximum operating pressures (MOP) up to and including 2 MPa (20 bar1)).

It specifies the definitions of electrofusion and butt fusion joints.

It also specifies the method of preparation of test piece joints and the tests to be carried out on these joints for assessing the fitness for purpose of the system under normal and extreme conditions.

In addition, it specifies the test parameters for the test methods to which it refers.

In conjunction with the other parts of ISO 22621, it is applicable to PA fittings, their joints and joints with components of PA.