Cena s DPH / bez DPH
Hlavní stránka>BS ISO 23274-1:2019 Hybrid-electric road vehicles. Exhaust emissions and fuel consumption measurements Non-externally chargeable vehicles
sklademVydáno: 2019-09-24
BS ISO 23274-1:2019 Hybrid-electric road vehicles. Exhaust emissions and fuel consumption measurements Non-externally chargeable vehicles

BS ISO 23274-1:2019

Hybrid-electric road vehicles. Exhaust emissions and fuel consumption measurements Non-externally chargeable vehicles

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
6240 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
624.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1872.00 Kč
Anglicky Tisk
Skladem
6240 Kč
Označení normy:BS ISO 23274-1:2019
Počet stran:30
Vydáno:2019-09-24
ISBN:978 0 539 02590 3
Status:Standard
Popis

BS ISO 23274-1:2019


This standard BS ISO 23274-1:2019 Hybrid-electric road vehicles. Exhaust emissions and fuel consumption measurements is classified in these ICS categories:
  • 43.120 Electric road vehicles

This document specifies a chassis dynamometer test procedure to measure the exhaust emissions and the electric energy and fuel consumption for the vehicles.

This document applies to vehicles with the following characteristics:

  • vehicles classified as passenger cars or light duty trucks, as defined in the relevant regional applicable driving test (ADT) standard;

  • the nominal energy of the rechargeable energy storage system (RESS) is at least 2Ã? % of the total energy consumption over an ADT;

  • internal combustion engine (ICE) only using liquid fuels (for example, gasoline and diesel fuel).

NOTE

In the case of the vehicles with ICE using other fuel [for example, compressed natural gas (CNG), liquefied petroleum gas (LPG), hydrogen], this document can apply except the measurement of consumed fuel; otherwise the measurement method for those using the corresponding fuel can apply.

This document proposes procedures for correcting the measured emissions and fuel consumption of hybrid-electric vehicles (HEVs), in order to obtain the values when the state of charge (SOC) of the RESS does not remain the same between the beginning and the end of an ADT.

It can also be applied to measurement procedures for exhaust emissions and fuel consumption of externally chargeable HEVs when a vehicle is not externally charged and operated only in the charge sustaining (CS) state, as described in ISO 23274-2.