BS ISO 6358-2:2019
Pneumatic fluid power. Determination of flow-rate characteristics of components using compressible fluids Alternative test methods
| Označení normy: | BS ISO 6358-2:2019 |
| Počet stran: | 50 |
| Vydáno: | 2019-09-16 |
| ISBN: | 978 0 539 00327 7 |
| Status: | Standard |
BS ISO 6358-2:2019
This standard BS ISO 6358-2:2019 Pneumatic fluid power. Determination of flow-rate characteristics of components using compressible fluids is classified in these ICS categories:
- 23.100.01 Fluid power systems in general
This document specifies a discharge test and a charge test as alternative methods for testing pneumatic fluid power components that use compressible fluids, i.e. gases, and that have internal flow passages that can be either fixed or variable in size to determine their flow-rate characteristics. However, this document does not apply to components whose flow coefficient is unstable during use, i.e. components that exhibit remarkable hysteretic behaviour (because they can contain flexible parts that deform under the flow) or that have an internal feedback phenomenon (such as regulators), or components that have a cracking pressure such as non-return (check) valves and quick-exhaust valves. In addition, it does not apply to components that exchange energy with the fluid during flow-rate measurement, e.g. cylinders, accumulators.
This document does not provide a method to determine if a component has hysteretic behaviour; ISO 6358-1 does provide such a method.
Table 1 provides a summary of which parts of the ISO 6358 series can be applied to various components.
| Components | Constant upstream pressure test | Variable upstream pressure test | |||
|---|---|---|---|---|---|
| constant upstream pressure test | charge test | variable upstream pressure test | discharge test | ||
| Group 1 | Directional control valves | yes | yes | yes | yes |
| Flow control valves | yes | yes | yes | yes | |
| Connectors | yes | yes | yes | yes | |
| Valve manifolds | yes | yes | yes | yes | |
| Group of components | yes | yes | yes | yes | |
| Group 2 | Filters and lubricators | yes | no | no | no |
| Non-return (check) valves | yes | no | no | no | |
| Quick-exhaust valves | yes | no | no | no | |
| Tubes and hoses | yes | no | no | no | |
| Group 3 | Silencers and exhaust oil mist separators | no | no | yes | yes |
| Blow nozzles | no | no | yes | yes | |
| Cylinder end heads | no | no | yes | yes | |
The charge test cannot be performed on components that do not have downstream port connections.
This document specifies requirements for the test installation, the test procedure, and the presentation of results.
Evaluation of measurement uncertainties is described in Annex A. Requirements for a method to test the volume of an isothermal tank are given in Annex B. Guidance on the isothermal tank is given in Annex C. Requirements for a method to test isothermal performance are given in Annex D. Guidance on the formula for calculating characteristics is given in Annex E. Guidance on calculating flow-rate characteristics is given in Annex F.