Cena s DPH / bez DPH
Hlavní stránka>BS ISO 6914:2021 Rubber, vulcanized or thermoplastic. Determination of ageing characteristics by measurement of stress relaxation in tension
Sponsored link
sklademVydáno: 2021-04-22
BS ISO 6914:2021 Rubber, vulcanized or thermoplastic. Determination of ageing characteristics by measurement of stress relaxation in tension

BS ISO 6914:2021

Rubber, vulcanized or thermoplastic. Determination of ageing characteristics by measurement of stress relaxation in tension

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4650 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
465.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1395.00 Kč
Anglicky Tisk
Skladem
4650 Kč
Označení normy:BS ISO 6914:2021
Počet stran:18
Vydáno:2021-04-22
ISBN:978 0 539 03324 3
Status:Standard
Popis

BS ISO 6914:2021


This standard BS ISO 6914:2021 Rubber, vulcanized or thermoplastic. Determination of ageing characteristics by measurement of stress relaxation in tension is classified in these ICS categories:
  • 83.060 Rubber

This document describes three methods for the measurement of the change of stress in a test piece at a given elongation for the purpose of determining the ageing characteristics of a rubber.

  • Method A is intended for measurement under continuous strain conditions.

  • Method B is the preferred method for measurement under intermittent strain conditions.

  • Method C is an alternative to method B for measurement under intermittent strain conditions in which the test piece is removed from the ageing environment for measurement of the stress at standard laboratory temperature.

Measurements at a single elevated ageing temperature can be used for quality control purposes as a measure of heat-ageing resistance. Measurements at a number of temperatures can be used for research and development purposes to estimate long-term ageing characteristics in accordance with the procedures described in ISO 11346.

Tests under continuous and intermittent strain conditions measure the results of different processes, and hence do not give the same results. The results of the intermittent methods B and C also cannot be expected to be the same as they use different test conditions.