Vážení zákazníci, v letošním roce budeme expedovat poslední objednávky ve středu 18. 12. 2024.

Těšíme se s vámi na shledanou od pondělí 06. 01. 2025.

 

Cena s DPH / bez DPH
Hlavní stránka>BS ISO 8709:2010 Mopeds. Brakes and brake systems. Tests and measurement methods
Sponsored link
sklademVydáno: 2010-05-31
BS ISO 8709:2010 Mopeds. Brakes and brake systems. Tests and measurement methods

BS ISO 8709:2010

Mopeds. Brakes and brake systems. Tests and measurement methods

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
6820 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
682.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2046.00 Kč
Anglicky Tisk
Skladem
6820 Kč
Označení normy:BS ISO 8709:2010
Počet stran:30
Vydáno:2010-05-31
ISBN:978 0 580 59333 8
Status:Standard
Popis

BS ISO 8709:2010


This standard BS ISO 8709:2010 Mopeds. Brakes and brake systems. Tests and measurement methods is classified in these ICS categories:
  • 43.140 Motorcycles and mopeds

This International Standard specifies tests and measurement methods for service brake systems and, where applicable, associated parking brake systems of two-wheeled mopeds (3-1) and three-wheeled mopeds (3-2) which are intended for use on public roads, in order to establish uniform worldwide test procedures for braking systems.

This International Standard does not cover mopeds which:

  • have a maximum speed of less than 25 km/h;

  • are equipped for disabled riders.

This International Standard sets out the following types of tests:

  • dynamic tests:

    • dry stop test (single brake control actuated);

    • wet brake test;

  • parking brake system test;

  • power-assisted brake system failure test.

NOTE The test methods (application, condition of the moped, test procedure and parameters, measurement of performances) for all the tests defined in this International Standard are equivalent to the corresponding test methods prescribed by UNECE Global Technical Regulation No. 3.