Cena s DPH / bez DPH
Hlavní stránka>DD IEC/PAS 62437:2005 Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices. Limits and methods of measurement. Specifications for active antennas
Sponsored link
sklademVydáno: 2006-01-18
DD IEC/PAS 62437:2005 Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices. Limits and methods of measurement. Specifications for active antennas

DD IEC/PAS 62437:2005

Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices. Limits and methods of measurement. Specifications for active antennas

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
4650 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
465.00 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
1395.00 Kč
Anglicky Tisk
Skladem
4650 Kč
Označení normy:DD IEC/PAS 62437:2005
Počet stran:16
Vydáno:2006-01-18
ISBN:0 580 47412 7
Status:Standard
Popis

DD IEC/PAS 62437:2005


This standard DD IEC/PAS 62437:2005 Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices. Limits and methods of measurement. Specifications for active antennas is classified in these ICS categories:
  • 33.100.20 Immunity
  • 33.100.10 Emission
Active antennas used on board vehicles are electronic components in the sense of CISPR 25. Therefore, the requirements regarding emissions apply to it in its function as EUT. In addition to this, vehicle active antennas are used as part of the measurement chain for the evaluation of emissions produced by any other component in the vehicle. With a passive antenna no special considerations were necessary because it can neither generate emissions nor harmonics due to its linearity. This Publicly Available Specification (PAS) gives additional information for the use of active antennas for radiated emission measurement according to CISPR 25. Test set-ups at component level are defined for the determination of noise floor.