ASTM A0662_A0662M-17 - Standard Specification for Pressure Vessel Plates, Carbon-Manganese-Silicon Steel, for Moderate and Lower Temperature Service
Standard Specification for Pressure Vessel Plates, Carbon-Manganese-Silicon Steel, for Moderate and Lower Temperature Service
| Označení normy: | A0662_A0662M-17 |
| Vydáno: | 01.11.2017 |
| Status: | Active |
| Počet stran: | 3 |
| Sekce: | 01.04 |
| Označení: | carbon steel; carbon steel plate; pressure containing parts; pressure vessel steels; steel plates for pressure vessels; |
1.1 This specification2 covers three grades of carbon-manganese-silicon steel plates intended primarily for service in welded pressure vessels where improved low temperature notch toughness is important.
1.2 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements.
1.3 For plates produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A20/A20M apply.
1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.