ASTM B0016_B0016M-24 - Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines
Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines
Označení normy: | B0016_B0016M-24 |
Vydáno: | 01.07.2024 |
Status: | Active |
Počet stran: | 5 |
Sekce: | 02.01 |
Označení: | Copper Alloy UNS No. C36000; Copper Alloy UNS No. C36010; free-cutting brass bar; free-cutting brass rod; free-cutting brass wire; screw machine rod; |
1.1 This specification covers the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloy UNS Nos. C36000 or C36010 suitable for high-speed screw machining applications and moderate thread rolling.
1.2 Units—Values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other and values from the two systems shall not be combined.
1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.