ASTM B0788_B0788M-09R20 - Standard Practice for Installing Factory-Made Corrugated Aluminum Culverts and Storm Sewer Pipe
Standard Practice for Installing Factory-Made Corrugated Aluminum Culverts and Storm Sewer Pipe
Označení normy: | B0788_B0788M-09R20 |
Vydáno: | 01.09.2020 |
Status: | Active |
Počet stran: | 5 |
Sekce: | 02.02 |
Označení: | aluminum pipe; corrugated aluminum pipe; culvert; installation; joining systems; sewers; underground installation; |
1.1 This practice describes procedures, soils, and soil placement for the proper installation of corrugated aluminum culverts and storm sewers in either trench or projection installations. A typical trench installation is shown in Fig. 1, and a typical embankment (projection) installation is shown in Fig. 2. The pipes described in this practice are manufactured in a factory and furnished to the job in lengths ordinarily from 10 to 30 ft [3 to 9 m], with 20 ft [6 m] being common, for field joining. This practice applies to structures designed in accordance with Practice B790/B790M.
FIG. 1 Typical Trench Installation
![Typical Trench Installation](http://www.astm.org/HTTP/IMAGES/B0788_B0788M_91682.png)
FIG. 2 Typical Embankment (Projection) Installation
![Typical Embankment (Projection) Installation](http://www.astm.org/HTTP/IMAGES/B0788_B0788M_91683.png)
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.