ASTM B1023-22 - Standard Test Method for Abrasion Resistance of Hard Anodic Coatings by a Taber-Type Abraser
Standard Test Method for Abrasion Resistance of Hard Anodic Coatings by a Taber-Type Abraser
Označení normy: | B1023-22 |
Vydáno: | 01.08.2022 |
Status: | Active |
Počet stran: | 8 |
Sekce: | 02.05 |
Označení: | abrader; abraser; abrasion; abrasion resistance; anodized alumimum; Taber-type; wear; |
1.1 This test method quantifies the abrasion resistance of electrolytically formed hard anodic oxidation coatings on a plane, rigid surface of aluminum or aluminum alloy.
1.2 This test uses a Taber-type abraser,2 which generates a combination of rolling and rubbing to cause wear to the coating surface. Wear is quantified as cumulative mass loss or loss in mass per thousand cycles of abrasion.
1.3 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
Note 1: The procedure described in Method A is similar to MIL-PRF-8625 (paragraph 4.5.5) and SAE AMS 2469 (paragraph 3.3.4). The procedure described in Method B includes a break-in period of 1000 cycles and is similar to ISO 10074 Annex B. When no procedure is specified, Method A shall be the default procedure. Although the procedures described in this method may be similar, they are not equivalent to Specification B893 or Test Method D4060.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.