ASTM C0157_C0157M-17 - Standard Test Method for Length Change of Hardened Hydraulic-Cement Mortar and Concrete
Standard Test Method for Length Change of Hardened Hydraulic-Cement Mortar and Concrete
Označení normy: | C0157_C0157M-17 |
Vydáno: | 15.08.2017 |
Status: | Active |
Počet stran: | 8 |
Sekce: | 04.02 |
Označení: | length change; mortar concrete; |
1.1 This test method covers the determination of the length changes that are produced by causes other than externally applied forces and temperature changes in hardened hydraulic-cement mortar and concrete specimens made in the laboratory and exposed to controlled conditions of temperature and moisture.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. An exception is with regard to sieve sizes and nominal size of aggregate, in which the SI values are the standard as stated in Specification E11. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.