ASTM C1305_C1305M-16R23 - Standard Test Method for Crack Bridging Ability of Liquid-Applied Waterproofing Membrane
Standard Test Method for Crack Bridging Ability of Liquid-Applied Waterproofing Membrane
Označení normy: | C1305_C1305M-16R23 |
Vydáno: | 01.09.2023 |
Status: | Active |
Počet stran: | 3 |
Sekce: | 04.04 |
Označení: | crack bridging; membrane; waterproofing; |
1.1 This test method covers a laboratory procedure for determining the ability of a waterproofing membrane to bridge a crack in the substrate.
1.2 There are no ISO standards similar or equivalent to this ASTM standard.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.