ASTM C1324-20A - Standard Test Method for Examination and Analysis of Hardened Masonry Mortar
Standard Test Method for Examination and Analysis of Hardened Masonry Mortar
Označení normy: | C1324-20A |
Vydáno: | 01.12.2020 |
Status: | Active |
Počet stran: | 7 |
Sekce: | 04.05 |
Označení: | chemical analysis; hardened mortar; masonry; petrographic examination; |
1.1 This test method covers procedures for petrographic examination and chemical analysis of samples of masonry mortars. Based upon such examination and analysis, proportions of components in masonry mortars can be determined.
Note 1: This method is also applicable to hydraulic cement-based stucco and plaster. Some historic mortars may contain non-resolvable constituents that may interfere. However, significant information may be obtained by petrographic examinations.
1.2 Interpretations and calculations of chemical results are dependent upon results of the petrographic examination. The use of the chemical results alone is contrary to the requirements of this test method.
1.3 Procedures for sampling, petrographic examination, chemical analysis, and calculations of component proportions are given in the following sections:
| Section |
Sampling | 7 |
Petrographic examination | 8 |
Chemical analysis | 9 |
Mortar proportion calculations | 10 |
Report | 11 |
1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.