ASTM C1369-19 - Standard Specification for Secondary Edge Sealants for Structurally Glazed Insulating Glass Units
Standard Specification for Secondary Edge Sealants for Structurally Glazed Insulating Glass Units
Označení normy: | C1369-19 |
Vydáno: | 01.01.2019 |
Status: | Active |
Počet stran: | 3 |
Sekce: | 04.07 |
Označení: | edge sealant; IG unit; insulating glass; secondary sealant; structural glazing ; |
1.1 This specification describes the properties of cold, liquid-applied, single or multi-component, chemically curing, elastomeric sealants used as the secondary seal of sealed insulating glass units, hereinafter referred to as the “sealant” (see Fig. 1). These sealants are intended to be a structural component of sealed insulating glass (IG) units used in structural sealant glazing (hereinafter referred to as SSG). Typical designs and considerations can be found in Guide C1249. Presently only certain silicone sealants are recognized as having the necessary durability for use as secondary sealant in IG units in SSG applications.
FIG. 1 Cutaway Section of IG Unit Edge Seal
![Cutaway Section of IG Unit Edge Seal](http://www.astm.org/HTTP/IMAGES/C1369_41267.png)
1.2 This specification does not describe all of the necessary properties of the sealant. Only those properties for which there are ASTM test methods and industry-agreed-upon minimum acceptable test requirements are described by this specification. Additional properties will be added as ASTM test methods for these properties become available.
1.3 This specification only addresses the durability of the secondary edge sealants for structurally glazed insulating glass units. Durability of sealed insulating glass units can be found in specifications and guides that reside within ASTM Committee E06.
1.4 The committee with jurisdiction for this standard is not aware of any comparable standard published by other organizations.
1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information purposes only.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.