B0775_B0775M-22 - Standard Specification for General Requirements for Nickel and Nickel Alloy Welded Pipe
Standard Specification for General Requirements for Nickel and Nickel Alloy Welded Pipe
Označení normy: | B0775_B0775M-22 |
Vydáno: | 01.04.2022 |
Status: | Active |
Počet stran: | 7 |
Sekce: | 02.04 |
Označení: | welded pipe; |
1.1 This specification contains various requirements that, with the exception of Section 5 and Section 10, are mandatory requirements to the following ASTM nickel and nickel alloy, longitudinally welded piping specifications:2
Title of Specification | ASTM |
| |
Welded UNS N08020 Alloy Pipe | B464/B464M |
Welded Nickel-Iron-Chromium Alloy Pipe | B514 |
Welded Nickel-Chromium-Iron-Alloy (UNS N06600, | B517 |
Welded Nickel and Nickel-Cobalt Alloy Pipe | B619/B619M |
UNS N08904, UNS N08925, and UNS N08926 Welded Pipe | B673 |
UNS N08367 Welded Pipe | B675 |
Nickel-Alloy (UNS N06625, N06219, and N08825) Welded Pipe | B705 |
Ni-Cr-Mo-Co-W-Fe-Si Alloy (UNS N06333) Welded Pipe | B723 |
Welded Nickel (UNS N02200/UNS N02201) and Nickel | B725 |
1.2 One or more of the test requirements of Section 5 apply only if specifically stated in the product specification or in the purchase order.
1.3 In case of conflict between a requirement of the product specification and a requirement of this general specification, only the requirement of the product specification needs to be satisfied.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.