Menu
0
Total price
0 €
PRICES include / exclude VAT
Homepage>BS EN 17892:2024 Water quality. Determination of selected per- and polyfluoroalkyl substances in drinking water. Method using liquid chromatography/tandem-mass spectrometry (LC-MS/MS)
sklademVydáno: 2024-06-21
BS EN 17892:2024 Water quality. Determination of selected per- and polyfluoroalkyl substances in drinking water. Method using liquid chromatography/tandem-mass spectrometry (LC-MS/MS)

BS EN 17892:2024

Water quality. Determination of selected per- and polyfluoroalkyl substances in drinking water. Method using liquid chromatography/tandem-mass spectrometry (LC-MS/MS)

Format
Availability
Price and currency
Anglicky Secure PDF
Immediate download
290.07 €
You can read the standard for 1 hour. More information in the category: E-reading
Reading the standard
for 1 hour
29.01 €
You can read the standard for 24 hours. More information in the category: E-reading
Reading the standard
for 24 hours
87.02 €
Anglicky Hardcopy
In stock
290.07 €
Označení normy:BS EN 17892:2024
Počet stran:44
Vydáno:2024-06-21
ISBN:978 0 539 22271 5
Status:Standard
DESCRIPTION

BS EN 17892:2024


This standard BS EN 17892:2024 Water quality. Determination of selected per- and polyfluoroalkyl substances in drinking water. Method using liquid chromatography/tandem-mass spectrometry (LC-MS/MS) is classified in these ICS categories:
  • 13.060.50 Examination of water for chemical substances
This document specifies a method for the determination of the dissolved fraction of selected perfluoroalkyl and polyfluoroalkyl substances (PFAS) in non-filtrated drinking water using liquid chromatography-tandem mass spectrometry (LC-MS/MS). The applicability of the method to other types of water like fresh waters (e.g. ground water, surface water) or treated wastewater can be validated separately for each individual case. For each target compound both, eventually occurring branched isomers and the respective non-branched isomer, are quantified together. The selected set of substances determined by this method is representative for a wide variety of PFAS. This method has been validated for the analytes specified in Table 1. The list given in this table can be modified depending on the purpose and focus of the method. The lower application range of this method can vary depending on the sensitivity of the equipment used and the matrix of the samples. For many substances to which this document applies a limit of quantification (LOQ) of 1 ng/l can be achieved. Using high volume direct injection as described in part A or SPE as described in part B of the method allows lower LOQs. Analytical limitations can occur with short-chain PFAS or PFAS with more than ten carbon atoms in the carbon chain. Actual LOQs can depend on the blank values realized by individual laboratories as well. NOTE This document enables the analysis of those 20 PFAS which are listed in point 3 of Part B of Annex III of the EU Drinking Water Directive, EU 2020/2184 [4], for the surveillance of the parametric limit value of 0,10 µg/l for the sum of PFAS. Furthermore, alternatives and substitutes for these PFAS substances can be analysed using this document as well. Table 1 - Analytes for which a determination was validated in accordance with this method