BS ISO 15202-1:2020
Workplace air. Determination of metals and metalloids in airborne particulate matter by inductively coupled plasma atomic emission spectrometry Sampling
| Označení normy: | BS ISO 15202-1:2020 |
| Počet stran: | 26 |
| Vydáno: | 2020-06-24 |
| ISBN: | 978 0 539 02292 6 |
| Status: | Standard |
BS ISO 15202-1:2020
This standard BS ISO 15202-1:2020 Workplace air. Determination of metals and metalloids in airborne particulate matter by inductively coupled plasma atomic emission spectrometry is classified in these ICS categories:
- 13.040.30 Workplace atmospheres
This document specifies a method for collecting samples of airborne particulate matter for subsequent determination of metals and metalloids using inductively coupled plasma — atomic emission spectrometry (ICP-AES). Samples obtained using the method described herein can also be subsequently analysed for elemental composition by other instrumental methods, such as atomic absorption spectrometry (AAS) or inductively coupled plasma mass spectrometry (ICP-MS).
The method is not applicable to the sampling of mercury, which is present in air in the vapour phase at ambient temperatures; inorganic compounds of metals and metalloids that are permanent gases, e.g. arsine (AsH3); or inorganic compounds of metals and metalloids that are present in the vapour phase at ambient temperatures, e.g. arsenic trioxide (As2O3).
Although the method does not describe a means of collecting inorganic compounds of metals and metalloids that are present in the vapour phase, in most instances this is relatively easily to achieve by using a back-up filter which has been pre-treated to trap the compound(s) of interest, e.g. a back-up paper pad impregnated with sodium carbonate is suitable for collecting arsenic trioxide (see ISO 11041 [ 2 ]).
The method is applicable to personal sampling of the inhalable, thoracic or respirable fraction of airborne particles, as defined in ISO 7708, and to static sampling.
This document excludes sampling of surfaces or bulk materials. Guidance on collection of samples for surfaces may be found in ASTM D7659[ 7].