BS ISO 8349:2002

This standard BS ISO 8349:2002 Road vehicles. Measurement of road surface friction is classified in these ICS categories:

• 93.080.99 Other standards related to road engineering
• 43.020 Road vehicles in general

This International Standard specifies test methods for determining the characteristic longitudinal friction force values of paved surfaces using either a standard reference test tyre or the tyre of a vehicle under test. General test procedures and their validity are presented for determining peak- and slide-braking coefficients on actual test surfaces, where the surface conditions are determined and controlled by the user at the time of testing. Test and test-surface condition documentation procedures and details are also specified.

The purpose of this International Standard is to provide for the harmonization of results of testing on different test tracks. The values measured with standard reference test tyres (SRTT) are intended to form standard reference numbers indicating the friction properties of test tracks and road surfaces that are representative for passenger car tyres.

Certain of the methods may also be suitable for measuring the friction properties for a specific test car tyre on the test track.

The values quantify the peak-, near-peak or slide-braking coefficients at the time of test and do not necessarily represent fixed values.

The values measured with reference tyres are intended as reference numbers indicating certain friction properties of test tracks and road surfaces.

This International Standard does not purport to address all the safety problems associated with its use. It is the responsibility of the user to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 1 Friction is affected by many variables such as environmental conditions, usage, age and surface contamination. Measured values will change when any of these conditions significantly changes.

NOTE 2 The measured braking coefficient values obtained with the procedures stated in this International Standard may not necessarily agree or correlate directly with those obtained by other surface coefficient measuring methods.