Cena s DPH / bez DPH
Hlavní stránka>PD CLC/TR 50485:2010 Electromagnetic compatibility. Emission measurements in fully anechoic chambers
Sponsored link
sklademVydáno: 2010-06-30
PD CLC/TR 50485:2010 Electromagnetic compatibility. Emission measurements in fully anechoic chambers

PD CLC/TR 50485:2010

Electromagnetic compatibility. Emission measurements in fully anechoic chambers

Formát
Dostupnost
Cena a měna
Anglicky Zabezpečené PDF
K okamžitému stažení
8556 Kč
Čtěte normu po dobu 1 hodiny. Více informací v kategorii E-READING
Čtení normy
na 1 hodinu
855.60 Kč
Čtěte normu po dobu 24 hodin. Více informací v kategorii E-READING
Čtení normy
na 24 hodin
2566.80 Kč
Anglicky Tisk
Skladem
8556 Kč
Označení normy:PD CLC/TR 50485:2010
Počet stran:48
Vydáno:2010-06-30
ISBN:978 0 580 64296 8
Status:Standard
Popis

PD CLC/TR 50485:2010


This standard PD CLC/TR 50485:2010 Electromagnetic compatibility. Emission measurements in fully anechoic chambers is classified in these ICS categories:
  • 33.100.10 Emission

This Technical Report applies to emission measurements of radiated electromagnetic fields in Fully Anechoic Rooms (FAR) in the frequency range from 30 MHz to 18 GHz. This Technical Report covers the frequency range from 30 MHz – 1 000 MHz. The frequency range above 1 GHz is under consideration, due to the absence of practical experience.

This Technical Report describes the validation procedure for the Fully Anechoic Room for radiated emission tests and the procedures to carry out the tests (e.g. test set up, EUT position, cable layout and termination, test procedures). Recommendations for the relation between FAR emission limits and common Open Area Test Site (OATS) emission limits given in standards such as EN 55011 and EN 55022 are given in Annex B.

This FAR emission method may be chosen by product committees as an alternative method to emission measurement on an Open Area Test Site (OATS) as described in CISPR 16 series. In such cases, the product committee should also define the appropriate limits. Typical measurement uncertainty values for FARs and OATS are given in Annex C.